|
[Sponsors] |
How to get the mesh quantity after mesh generation? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 7, 2012, 12:54 |
How to get the mesh quantity after mesh generation?
|
#1 |
Member
X Meng
Join Date: Jun 2012
Location: Scotland
Posts: 89
Rep Power: 13 |
Hi guys, can abybody tell me how to get the mesh quantity after mesh generation? I can't find the way ....
|
|
June 7, 2012, 13:00 |
|
#2 |
Senior Member
Henry Arrigo
Join Date: Jun 2010
Location: Italy
Posts: 100
Rep Power: 15 |
Hi
You can go to Mesh>Diagnostics... . Use either compact or full report. It provides you enough information about the mesh. |
|
June 7, 2012, 13:08 |
|
#3 |
Member
Ryan Coe
Join Date: Jun 2010
Location: Albuquerque, NM
Posts: 98
Rep Power: 15 |
You can also look at "Volume Mesh" (or any other representation) under the "Representations" tab.
__________________
Ryan |
|
June 8, 2012, 03:43 |
|
#4 |
Member
X Meng
Join Date: Jun 2012
Location: Scotland
Posts: 89
Rep Power: 13 |
Haha, got it! Thank you guys !
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
[Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
[ICEM] Unstructure Meshing Around Imported Plot3D Structured Mesh ICEM | kawamatt2 | ANSYS Meshing & Geometry | 17 | December 20, 2011 11:45 |
mesh generation for in-cylinder fluent simulation | hennas | ANSYS Meshing & Geometry | 2 | May 31, 2011 15:08 |
Mesh generation software is needed | H.Dou | Main CFD Forum | 12 | May 4, 2011 15:20 |