 |
 |
 |
|
|
|
[Sponsors] | ||||
June 5, 2012, 17:33
|
VOF model error
|
#1 |
|
New Member
Join Date: Apr 2012
Location: OR USA
Posts: 12
Rep Power: 14  |
Hi all,
I was doing a simulation similar to the "Boiling with VOF tutorial". (Basically, only the geometry is different). But when I ran it, a error came out(see picture below). Can anyone tell what's wrong here? 
Last edited by bryan he; June 5, 2012 at 17:40. Reason: picture didn't show up |
|
|
|
|
|
June 5, 2012, 21:15
|
|
#2 |
|
Senior Member
KHB
Join Date: Aug 2010
Location: Singapore
Posts: 118
Rep Power: 15 |
Hmm I do not see any picture, are you sure you have attached it?
|
|
|
|
|
|
|
June 6, 2012, 16:58
|
|
#3 |
|
New Member
Join Date: Apr 2012
Location: OR USA
Posts: 12
Rep Power: 14 |
I've solved this problem. Thanks all the same!
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Compile calcMassFlowC | aurore | OpenFOAM Programming & Development | 13 | March 23, 2018 07:43 |
| Undeclared Identifier Errof UDF | SteveGoat | Fluent UDF and Scheme Programming | 7 | October 15, 2014 07:11 |
| checking the system setup and Qt version | vivek070176 | OpenFOAM Installation | 22 | June 1, 2010 12:34 |
| compile errors of boundary condition "expDirectionMixed" | liying02ts | OpenFOAM Bugs | 2 | February 1, 2010 20:11 |
| error while compiling the USER Sub routine | CFD user | CFX | 3 | November 25, 2002 15:16 |
Linear Mode
