Boundary layer first cell distance
Hi
I would like to start my first prism cells for my boundary layer at a distance of say 0.00001 away from the wall, im a bit confused about the type of stretching mode i have to use to get that required distance...could someone help me out please... Regards |
If you go to Continua-Mesh-Models-Prism Layer Mesher, you can select the Stretching Mode: choose Wall Thickness.
Then, under Continua-Mesh-Referece Values-Thickness of Near Wall Prism Layer, you can set your desired thickness. Hope this helps, Ryan |
All times are GMT -4. The time now is 10:29. |