|July 21, 2012, 13:41||
Join Date: May 2012
Posts: 43Rep Power: 6
my problem, I have two pipes, the union between both is a interface (in place), I mean my first outlet with my second inlet in the second pipe. I have done "inizialize", all it is right, starccm+ recognizes the interface, but I get the Physics values in my second inlet that I write in the Physics values and not got the values from my first outlet.
I attached picture.
|July 28, 2012, 05:27||
Join Date: Oct 2009
Posts: 637Rep Power: 14
When both regions are in the same physics continuum, you will get the same initialisation for both regions, no matter if there's an interface or not. The interface will only have an effect on the solving process, not for initialisation
We do three types of jobs here:
GOOD, FAST AND CHEAP
You may choose any two!
|Thread||Thread Starter||Forum||Replies||Last Post|
|Wind turbine simulation||Saturn||CFX||45||February 8, 2016 05:42|
|RPM in Wind Turbine||Pankaj||CFX||9||November 23, 2009 05:05|
|CFX Solver Memory Error||mike||CFX||1||March 19, 2008 08:22|
|Convective Heat Transfer - Heat Exchanger||Mark||CFX||6||November 15, 2004 16:55|
|Replace periodic by inlet-outlet pair||lego||CFX||3||November 5, 2002 21:09|