|
[Sponsors] |
July 21, 2012, 13:41 |
interface
|
#1 |
Member
David L
Join Date: May 2012
Posts: 43
Rep Power: 13 |
Hello everyone,
my problem, I have two pipes, the union between both is a interface (in place), I mean my first outlet with my second inlet in the second pipe. I have done "inizialize", all it is right, starccm+ recognizes the interface, but I get the Physics values in my second inlet that I write in the Physics values and not got the values from my first outlet. I attached picture. |
|
July 28, 2012, 05:27 |
|
#2 |
Senior Member
Join Date: Oct 2009
Location: Germany
Posts: 636
Rep Power: 21 |
When both regions are in the same physics continuum, you will get the same initialisation for both regions, no matter if there's an interface or not. The interface will only have an effect on the solving process, not for initialisation
__________________
We do three types of jobs here: GOOD, FAST AND CHEAP You may choose any two! |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
CFX Solver Memory Error | mike | CFX | 1 | March 19, 2008 07:22 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 20:09 |