|October 10, 2012, 00:03||
Join Date: Oct 2011
Posts: 52Rep Power: 6
This is my geometry:
When I mesh with trimmer using a volumetric control around it:
Why does the mesh seem to intersect like that and create those lines? Those geometries are not overlapping, but they are touching (mated in SolidWorks). Also, in the original geometry the corners are rounded by when it gets meshed it gets 'truncated'. How to fix this?
|October 10, 2012, 02:57||
Join Date: Aug 2011
Posts: 26Rep Power: 6
just check in the contour plots - which parts u have included. if feature curves are there in the parts, just remove those and check it again and it will helpful.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Dynamic Mesh Problem.||Tom Clark||FLUENT||9||July 7, 2010 07:56|
|Icemcfd 11: Loss of mesh from surface mesh option?||Joe||CFX||2||March 26, 2007 18:10|
|Gambit problems||Althea||FLUENT||21||February 6, 2001 08:05|
|Convergence problem when ustructured mesh is used.||SangJin Ryu||CD-adapco||3||October 5, 2000 20:26|
|Mesh||Mignard||FLUENT||2||March 22, 2000 06:12|