|January 21, 2013, 16:43||
Pressure Plot for a Turbine Blade
Join Date: Dec 2012
Posts: 33Rep Power: 5
I am simulating a turbine blade and I am getting errors that I have no idea how to get rid of. The pressure plot I have attached shows a seperation bubble near the trailing edge which is correct however the bump before it should not be there (just after the suction peak), also the area of suction on the front of the turbine blade is way to large and it should be alot smaller.
Does anyone know how to solve either of these issues.
|pressure plot, seperation, turbine blade|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Plot pressure distribution on a section of 3d blade||Dr.been||FLUENT||2||July 22, 2016 05:03|
|[ICEM] Turbine blade with filleting and tip clearance||Pursuor||ANSYS Meshing & Geometry||4||July 7, 2010 13:56|
|How to plot change in pressure over time for a point in the mesh||johan||OpenFOAM Paraview & paraFoam||4||November 12, 2008 08:21|
|plot pressure distribution on a section of 3D wing||ROOZBEH||FLUENT||3||April 21, 2008 03:30|
|Does star cd takes reference pressure?||monica||CD-adapco||1||April 19, 2007 11:26|