Turbo Wizard

badger1 · March 9, 2013, 06:19

Hi,

I am trying to create a linear cascade in Starccm+ using the turbo wizard. There are tutorials for the anular setup but not the linear. To make the turbo wizard work you need inlet, outlet, hub and tip files that specify coordinates however I cant seem to figure out how they work or what they would need to be in order to make my cascade work.

does anyone have any experience with a linear cascade using Star as any help would be greatly appriciated.

Thanks

badger1 · March 11, 2013, 16:24

just incase anyone thinks it is relivant, whenever I try to run the turbowizard in linear mode i get the error message

'Error:SurfaceSectioner::createSection()

id not find any intersections with surface.
Problem occurred during grid generation.'

despite when plotting the coordinates for the hub,tip,inlet and outlet on a drawing package they clearly intersect.

thanks

D.Sz · November 23, 2014, 12:52

Just wondering if you've solved this?
I was trying to work with Turbo Wizard, but I keep getting that exact error message and am out of ideas by now...
Note: mine is a annular problem.

March 9, 2013, 06:19	Turbo Wizard	#1
badger1 Member anonymous Join Date: Dec 2012 Posts: 33 Rep Power: 13	Hi, I am trying to create a linear cascade in Starccm+ using the turbo wizard. There are tutorials for the anular setup but not the linear. To make the turbo wizard work you need inlet, outlet, hub and tip files that specify coordinates however I cant seem to figure out how they work or what they would need to be in order to make my cascade work. does anyone have any experience with a linear cascade using Star as any help would be greatly appriciated. Thanks

March 11, 2013, 16:24		#2
badger1 Member anonymous Join Date: Dec 2012 Posts: 33 Rep Power: 13	just incase anyone thinks it is relivant, whenever I try to run the turbowizard in linear mode i get the error message 'Error:SurfaceSectioner::createSection()id not find any intersections with surface. Problem occurred during grid generation.' despite when plotting the coordinates for the hub,tip,inlet and outlet on a drawing package they clearly intersect. thanks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[GAMBIT] problems with gambit tools turbo	qxtxdy	ANSYS Meshing & Geometry	0	October 15, 2010 22:33
gambit turbo file format	ventoneac_diana	Main CFD Forum	0	April 29, 2010 12:02
Gambit turbo problem.	sujan.dasmahapatra	FLUENT	0	December 20, 2009 05:21
Turbo question	spacewatcer	FLUENT	0	May 29, 2009 17:03
Problem running FINE Turbo	Michal Vanco	Fidelity CFD	0	June 7, 2004 06:58

November 23, 2014, 12:52		#3
D.Sz New Member Dagmara Join Date: Nov 2014 Posts: 1 Rep Power: 0	Just wondering if you've solved this? I was trying to work with Turbo Wizard, but I keep getting that exact error message and am out of ideas by now... Note: mine is a annular problem.