 |
 |
 |
|
|
|
[Sponsors] | ||||
April 22, 2013, 02:55
|
Trouble with water-air interface
|
#1 |
|
New Member
Join Date: Mar 2013
Posts: 3
Rep Power: 2  |
Hello,
I am simulating a free fall lifeboat according to the tutorial, but for some reason my volume fraction of water scene displays the air-water interface very distorted. The first time I ran the solution everything was fine, but after some mesh improvements it became this way (see picture). I have also tried with the original mesh settings again, and clearing the solution. Any suggestions on what to try? |
|
|
|
|
|
April 22, 2013, 08:10
|
|
#2 |
|
New Member
Join Date: Mar 2013
Posts: 3
Rep Power: 2 |
I solved it.
|
|
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 23 | April 16, 2011 07:34 |
| mass flow in is not equal to mass flow out | saii | CFX | 2 | September 18, 2009 08:07 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
| Help!!!problems in air jet into water bath | kim | FLUENT | 4 | June 9, 2003 07:04 |
| Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 20:09 |
Linear Mode
