 |
 |
 |
|
|
|
[Sponsors] | ||||
May 8, 2013, 12:13
|
reason for divergence
|
#1 |
|
New Member
Rohit Ray
Join Date: Jun 2011
Location: India
Posts: 4
Rep Power: 3  |
I am running a simulation for a sphere with seam in air flow. when i rotated the seam and ran the simulation again, the solution is not converging. I did keep all the conditions same as the earlier case.
Can suggest me what to check if your Tke and Tdr aren't converging? |
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] What is the reason for this negative determinant? | kiddmax | ANSYS Meshing & Geometry | 6 | April 18, 2013 10:59 |
| Reason for oscillating residuals | fayaazhussain | Main CFD Forum | 2 | June 27, 2011 12:51 |
| Reason for asymmetry in symmetric geometries | doubtsincfd | Main CFD Forum | 1 | June 10, 2010 08:13 |
| Discussion: Reason of Turbulence!! | Wen Long | Main CFD Forum | 3 | May 15, 2009 09:52 |
| Reason of divergence ? | Brayton | Main CFD Forum | 3 | December 2, 2000 22:34 |
Linear Mode
