|May 14, 2013, 11:50||
Join Date: Feb 2013
Posts: 2Rep Power: 0
I'm simulating a planing hull by ccm+ at about Fn=1.2.
By the volume fraction of water I found a little quantity of air below the hull.
This phenomenon induces also wrong trim and resistance value.
I heard about an anti-ventilation method used to correct the drag value deducting, from some cells (only the cells that have less of 50% of water), a small percentage of air.
I try this method but I found some difficult to apply it.
I write a custom field function called "zone" that compute the volume from which deduct air. ($WallDistance > .003)?0 : (($VolumeFractionWater < .5)?0 : 1)
Then I write a function called "airsource" by which is possible deduct air: $VolumeFractionAIR*$zone / -.03
The problem is: I'm not able to compute the new drag considering that deduction.
Could you help me?
|Thread||Thread Starter||Forum||Replies||Last Post|
|discretizer - gmshToFoam||Andyjoe||Open Source Meshers: Gmsh, Netgen, CGNS, ...||13||March 14, 2012 06:35|
|Fluent 6.3.26 vs 12.1 and partition method||Anorky||FLUENT||0||April 27, 2010 11:55|
|Code for most powerfull FDV Method||D.S.Nasan||Main CFD Forum||6||September 4, 2008 03:08|
|Help about the preconditioner in gmres method||Dan Gao||Main CFD Forum||3||July 5, 2008 02:18|
|hess-smith method and fvm method||yangqing||FLUENT||0||March 20, 2002 20:25|