 |
 |
 |
|
|
|
[Sponsors] | ||||
June 4, 2013, 12:34
|
Cell size near boundaries
|
#1 |
|
New Member
Carlos Michelen
Join Date: Jun 2013
Posts: 1
Rep Power: 0  |
I am a new user of Star CCM+, and I realize this is a very basic question. How do I specify the cell size at the region boundary? This is very easy if I were using prismatic mesh, but I just want the polyhedral mesh to decrease in size as it approaches the end of the Region. I could not find how to do it in the User Guide. Thanks!
|
|
|
|
|
 |
| Tags |
| cell size, polyhedral mesh |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cell Reynolds Number | laliong | Main CFD Forum | 12 | September 17, 2019 03:18 |
| interFoam running blowing up | sandy13 | OpenFOAM Running, Solving & CFD | 2 | May 5, 2015 07:16 |
| Cell element size | sys999 | ANSYS Meshing & Geometry | 1 | January 30, 2011 17:24 |
| critical error during installation of openfoam | Fabio88 | OpenFOAM Installation | 21 | June 2, 2010 03:01 |
| cell size | Baskar | Siemens | 4 | January 18, 2006 13:34 |
Linear Mode
