Splitting a circle out of a plane rectengular surface

hebeldebel · March 27, 2014, 09:28

Hi,

I am modifying an old CCM+ simulation which has parts imported from a CAD tool unknown to me.

There is a surface at Geometry->Parts->"Partname"->Surfaces->"Surfacename".

It is a rectangular plane and I would like to split it into 3 surfaces: two circles fully surrounded by the rectangular plane (at a specific location and with a defined diameter).

Is this possible, or do I need to modify the part with a CAD tool?

Thank you for your help.

kind regards,
hebeldebel

ping · March 27, 2014, 09:32

if it is 'real' cad that has been imported you can edit it in 3d-cad and draw the required circles on the surface and then imprint this sketch on to the surface to split it

if not then make some some cylinders in parts and do an imprint mesh operation in parts

hebeldebel · March 27, 2014, 09:34

thank you very much for your answer, I will try it right away

edit: worked like a charm!

March 27, 2014, 09:28	Splitting a circle out of a plane rectengular surface	#1
hebeldebel Member Join Date: Jan 2014 Posts: 40 Rep Power: 12	Hi, I am modifying an old CCM+ simulation which has parts imported from a CAD tool unknown to me. There is a surface at Geometry->Parts->"Partname"->Surfaces->"Surfacename". It is a rectangular plane and I would like to split it into 3 surfaces: two circles fully surrounded by the rectangular plane (at a specific location and with a defined diameter). Is this possible, or do I need to modify the part with a CAD tool? Thank you for your help. kind regards, hebeldebel

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Gmsh] Hex with transfinite Volume	Mjoelnir	OpenFOAM Meshing & Mesh Conversion	8	March 30, 2017 08:52
udf to create surface plane (aligned to a surface)	Ananthakrishnan	Fluent UDF and Scheme Programming	0	May 23, 2013 14:30
Plane stress and plane strain cases for stress analysis	Sargam05	OpenFOAM	0	May 3, 2013 18:16
[Gmsh] boundaries with gmshToFoam‏	ouafa	OpenFOAM Meshing & Mesh Conversion	7	May 21, 2010 12:43
solid edge problem....can you help?	cindy	Main CFD Forum	3	April 5, 2004 13:43

March 27, 2014, 09:32		#2
ping Senior Member Ping Join Date: Mar 2009 Posts: 556 Rep Power: 20	if it is 'real' cad that has been imported you can edit it in 3d-cad and draw the required circles on the surface and then imprint this sketch on to the surface to split it if not then make some some cylinders in parts and do an imprint mesh operation in parts

March 27, 2014, 09:34		#3
hebeldebel Member Join Date: Jan 2014 Posts: 40 Rep Power: 12	thank you very much for your answer, I will try it right away edit: worked like a charm!