|
[Sponsors] |
December 6, 2016, 11:02 |
Errors in simulation result by using VOF
|
#1 |
New Member
Xiang Pan
Join Date: Jun 2015
Posts: 3
Rep Power: 10 |
Hi,
I am using Star-ccm+ to simulate Taylor bubbles generated by a cross-shaped junction in 2D. The models I used are: Eulerian multiphase Implicit unsteady Laminar Segregated flow VOF I found that there are always some errors around the bubble I generated which is shown in the picture attached. problem.PNG I tried to increase mesh number from 10k to 50k but it still doesn't work. Any suggestion to reduce these errors? Thank you. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Building OpenFOAM1.7.0 from source | ata | OpenFOAM Installation | 46 | March 6, 2022 14:21 |
Transient simulation not converging | skabilan | OpenFOAM Running, Solving & CFD | 14 | December 17, 2019 00:12 |
Unexpected deltaT decrease in pimpleFoam simulation | robyTKD | OpenFOAM Running, Solving & CFD | 9 | June 27, 2014 07:52 |
Micro Scale Pore, icoFoam | gooya_kabir | OpenFOAM Running, Solving & CFD | 2 | November 2, 2013 14:58 |
Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 05:03 |