|
[Sponsors] |
Report type to calculate pressure at sensor position |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 9, 2015, 05:21 |
Report type to calculate pressure at sensor position
|
#1 |
Member
Kamal Bisht
Join Date: Jun 2015
Location: Germany
Posts: 57
Rep Power: 10 |
Hi, I am simulating multiphase flow (water and air) in a pipe. I have pressure values as experimental data to verify simulation results. The pressure values are recorded by sensors intalled at various locations in pipe (some at the position where air is a dominant fluid and some in the Water dominant region).
I am confused which report type I should use to get the pressure value at the specific location. I tried with surface average and mass flow average report over a cross sectional plane but the data is not right as the plane is also taking the cell value of the water dominant region. Line probe is giving me only the maximum and minimum value of pressure in desired position. Also to calculate volume fraction of water on the cross sectional plane which report is appropriate? |
|
November 9, 2015, 09:00 |
|
#2 |
Senior Member
Matt
Join Date: Aug 2014
Posts: 947
Rep Power: 17 |
create a derived part > probe > point then create a report (use max or min, it doesn't matter) then assign the derived part as your input part and choose pressure (static/total/absolute/etc...) as your field function.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM.org] compile error in dynamicMesh and thermophysicalModels libraries | NickG | OpenFOAM Installation | 3 | December 30, 2019 00:21 |
Why Menter's SST model low-Re issue has not been seriously investigated? | vkrastev | OpenFOAM | 58 | January 8, 2018 15:20 |
Pressure rising indefinitely with rhoSimpleFoam | Werne | OpenFOAM Running, Solving & CFD | 3 | April 16, 2015 23:42 |
An error has occurred in cfx5solve: | volo87 | CFX | 5 | June 14, 2013 17:44 |
[swak4Foam] Air Conditioned room groovyBC | Sebaj | OpenFOAM Community Contributions | 7 | October 31, 2012 14:16 |