|
[Sponsors] |
February 11, 2016, 08:47 |
assign a temperature to a boundary
|
#1 |
Member
Nils
Join Date: Nov 2015
Posts: 59
Rep Power: 10 |
Hi,
Im modelling an isothermal fluid flow with an disepersed lagrangian phase. For the wall impegments, I wanna model a breakup, depending on the impact-weber-number. Until now I used the satoh-model, which filters particles with high impact-weber-number. In realgas flows, those droplets would breakup into some smaller ones. Therefor in star ccm, I can use the bai-onera or bai-gosman wall impigment model. But those models needs a boundary-temperature to compute the physics. Is there any possibilty to assign a walltemperature to the boundary? best regards! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
Domain Imbalance | HMR | CFX | 5 | October 10, 2016 05:57 |
domain imbalance for enrgy equation | happy | CFX | 14 | September 6, 2012 01:54 |
natural convection | mehrdadeng | CFX | 10 | February 25, 2011 05:25 |
Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 6, 2008 23:17 |