 |
 |
 |
|
|
|
[Sponsors] | ||||
December 5, 2016, 09:52
|
Duplicate/extrude geometry in Star
|
#1 |
|
New Member
Delchini Marc-Olivier
Join Date: Dec 2016
Posts: 7
Rep Power: 9  |
Hello,
I am fairly new to Star and am trying to achieve the following: I have a geometry that was generated from a CAD model and then meshed with HEXPRESS. The geometry was successfully imported in Star. The geometry is of periodic length L and what I want to extend it to 2L but with the same periodic length L. I am not sure how to proceed from here. One option would be to duplicate my original geometry and then merge the two geometries in a single one. Any help on this matter would be greatly appreciated. Thanks, Marco |
|
|
|
|
|
December 19, 2016, 00:34
|
|
#2 | |
|
Senior Member
Join Date: Nov 2010
Location: USA
Posts: 1,232
Rep Power: 24 |
Quote:
|
||
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [DesignModeler] Fill tool - grouping the faces of a complicated geometry? | HeikkiT | ANSYS Meshing & Geometry | 8 | July 20, 2016 07:37 |
| Geometry for Confined Circular Jet | Greatness | FLUENT | 0 | October 1, 2013 05:04 |
| Export geometry file from ansys mechanical | browns6 | Structural Mechanics | 0 | August 27, 2013 16:19 |
| Problem Importing Geometry ProE to CFX | fatb0y | CFX | 3 | January 14, 2012 19:42 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
Linear Mode
