CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   STAR-CCM+ (http://www.cfd-online.com/Forums/star-ccm/)
-   -   Problem running parallel. (http://www.cfd-online.com/Forums/star-ccm/71248-problem-running-parallel.html)

Hernán December 21, 2009 10:56

Problem running parallel.
 
1 Attachment(s)
Hello, good afternoon,


We have a problem with a pc we have purchased last week; we want to run a simulation
in parallel mode but a message error appears (enclosed txt). The pc has 8 cores and the
operating system is windows7; we have installated mpich for win 64 at this computer, is
it ok? We think the problem is at the mpi driver or something simmilar, highlight that on
serial mode the simulation works well.


Thank´s for tour attention.

We remain at your disposition for any doubt.

Best regards,

TMG December 23, 2009 13:04

Parallel
 
The key warning is that it cannot find the MPI distribution. My guess is that you don't have the path to the mpi executables set in your path. It looks to me that mpich was either not installed properly or perhaps not installed for use by all users?


All times are GMT -4. The time now is 15:47.