|December 27, 2009, 17:27||
solid region empty or not?
Join Date: Nov 2009
Posts: 9Rep Power: 7
I'm sorry for the question, these are the first times i approach the cfd simulation.
I have realized a model of heat shield for a exaust pipe.
I made two regions: a fluid and a solid .
My question is for the shield that belong two the solid region .
You can immagine it as a semi -shell that is close in eash side by boundaries belonging to solid region.
When i make my volume mesh and then i make a section it seems to be empty inside . It's normal? Becouse monitoring the section temperature during simulation , I can't understand if inside is empty or not.
I set parameters like thermal conductivity inside the continuum , but I've seen you can set it also in the interfaces. So i think that the first is for the material inside the solid continuum ,while the second is only for the contact interface with fluid (air) region ? Is that correct?
|January 7, 2010, 09:35||
Join Date: Oct 2009
Posts: 637Rep Power: 12
But i'm sorry, i couldn't understand your problem with the emty region. Maybe you could post an image?
|Thread||Thread Starter||Forum||Replies||Last Post|
|solid region empty or not?||Trofrensis||STAR-CCM+||0||December 27, 2009 17:26|
|Extracting fluid flow region from a solid body 3D||Pradeep||Main CFD Forum||6||January 29, 2009 12:13|
|Trimmed cell and embedded refinement mesh conversion issues||michele||OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...||2||July 15, 2005 04:15|
|Import gmsh msh to Foam||adorean||Open Source Meshers: Gmsh, Netgen, CGNS, ...||24||April 27, 2005 08:19|
|CFX4.3 -build analysis form||Chie Min||CFX||5||July 12, 2001 23:19|