|
[Sponsors] |
December 27, 2009, 16:26 |
solid region empty or not?
|
#1 |
New Member
Francesco
Join Date: Nov 2009
Posts: 9
Rep Power: 16 |
Hi
I'm sorry for the question, these are the first times i approach the cfd simulation. I have realized a model of heat shield for a exaust pipe. I made two regions: a fluid and a solid . My question is for the shield that belong two the solid region . You can immagine it as a semi -shell that is close in eash side by boundaries belonging to solid region. When i make my volume mesh and then i make a section it seems to be empty inside . It's normal? Becouse monitoring the section temperature during simulation , I can't understand if inside is empty or not. I set parameters like thermal conductivity inside the continuum , but I've seen you can set it also in the interfaces. So i think that the first is for the material inside the solid continuum ,while the second is only for the contact interface with fluid (air) region ? Is that correct? Last edited by Trofrensis; December 27, 2009 at 17:19. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Extracting fluid flow region from a solid body 3D | Pradeep | Main CFD Forum | 6 | January 29, 2009 11:13 |
Treatment of solid region in collocated grid | Yongpan Cheng | Main CFD Forum | 0 | December 10, 2006 22:27 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
[Gmsh] Import gmsh msh to Foam | adorean | OpenFOAM Meshing & Mesh Conversion | 24 | April 27, 2005 08:19 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |