Massflow report/monitor in CCM+
Hello,
I'm simulating a radial impeller. I've modeled a single channel with periodic BC's and so far I'm getting very good results. The simulation converges quickly, the velocities and pressures are right but the massflow is about 1/100 if the expected values. Even when I use a massflow inlet and specify the correct flow the report shows low values. I'm pretty sure that the results are physical but I'm doing something wrong while creating the report/monitor. Any ideas? |
Check the size of your domain. Maybe there is something wrong with meters and feet.
|
Hi beilke,
I've checked and the domain is fine. The speeds and pressures are also fine. Is the massflow averaged over the entire patch or is it indicative of only one cell? |
Solved it!
I was using area averaged and not massflow report. :) |
All times are GMT -4. The time now is 17:27. |