|
[Sponsors] |
September 22, 2010, 13:28 |
mesh intersecting another mesh
|
#1 |
New Member
ahmad bakri
Join Date: May 2010
Posts: 20
Rep Power: 15 |
hi all,
I am simulating a process (friction stir processing) where a tool (has cylindrical geometry and small cylindrical pin) is imprinted in a sheet that is designed with a hole ( Where the pin is inserted ), now the tool should rotate and then move linearly, I still dont know how to transfer the interface (in the sheet region) with the moving tool....does anyone have an idea??? in case the interface didnt follow the tool, then the pin of the tool will get inside the closed mesh of the sheet....I am using a direct interface (in place) between the tool and the sheet, does changing the interface type help?? thanks |
|
September 23, 2010, 12:39 |
|
#2 |
Member
John
Join Date: Aug 2009
Posts: 92
Rep Power: 16 |
Is this a flow simulation or are you using starccm just for meshing purposes?
|
|
September 24, 2010, 05:26 |
|
#3 |
New Member
ahmad bakri
Join Date: May 2010
Posts: 20
Rep Power: 15 |
yes this is a flow problem, I am simulating the process by assuming the fluid as non Newtonian fluid and heat is generated by deformation
|
|
October 2, 2010, 15:56 |
|
#4 |
Senior Member
Join Date: Oct 2009
Location: Germany
Posts: 636
Rep Power: 21 |
I'm not fully sure whether I've understood it the right way... Maybe you can post a picture?
My current guess would be, you have to use the morpher to model the translation, but it will be more clear with a picture... |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dynamic Mesh Problem. | Tom Clark | FLUENT | 10 | June 21, 2021 04:27 |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
engrid -> save as .stl with boundarie codes | Zymon | enGrid | 31 | August 29, 2011 13:40 |
[ICEM] Hexa Mesh Smoothing | Jules | ANSYS Meshing & Geometry | 6 | December 4, 2010 18:00 |
basic of mesh refinement | arya | CFX | 4 | June 19, 2007 12:21 |