|
[Sponsors] |
March 2, 2011, 05:57 |
one cell thick mesh
|
#1 |
New Member
Join Date: Feb 2011
Posts: 13
Rep Power: 15 |
Hi everyone,
i'm trying to modell a one cell thick case with starccm+. it's a body inside a calculation domain. i want to have a one cell thick mesh on the surface of the body too. is it possible? regards michael=) |
|
March 3, 2011, 02:18 |
|
#2 |
Senior Member
Join Date: Oct 2009
Location: Germany
Posts: 636
Rep Power: 21 |
Not sure I've understood you the right way. Should it be a 2D simulation?
What do you mean with "i want to have a one cell thick mesh on the surface of the body too."? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
[ICEM] Negative volume error in hybrid mesh | siw | ANSYS Meshing & Geometry | 4 | September 3, 2014 05:25 |
[snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 19:43 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
How to control Minximum mesh space? | hung | FLUENT | 7 | April 18, 2005 09:38 |