|
[Sponsors] |
"Attempt to access unallocated DensityLevel1 storage in cells Inlet" |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Senior Member
Join Date: Dec 2010
Posts: 135
Rep Power: 15 ![]() |
Hi
I am running a unsteady implicit k-e Modell Model. Always if I am going to start my simulation this failure comes up: "Attempt to access unallocated DensityLevel1 storage in cells Inlet" I donīt get it, my simulation worked before (with a smaller mesh), I just increased the mesh resolution and thatīs it. Anynone can help? Thanks |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Senior Member
siamak rahimi ardkapan
Join Date: Jul 2010
Location: Copenhagen, Denmark
Posts: 220
Rep Power: 17 ![]() |
Hi,
I got the same error and I solved it as follow: In the " Representations" I removed all meshes except "Volume mesh". from " Volume mesh" I extracted the surface mesh. The problem was solved. I think the reason is that, volume mesh and surface mesh became the same. Good luck |
|
![]() |
![]() |
![]() |
![]() |
#3 | |
Senior Member
Ryne Whitehill
Join Date: Aug 2009
Posts: 312
Rep Power: 18 ![]() |
Quote:
|
||
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 08:54 |
[Netgen] Import netgen mesh to OpenFOAM | hsieh | OpenFOAM Meshing & Mesh Conversion | 32 | September 13, 2011 05:50 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
[snappyHexMesh] snappyHexMesh aborting | Tobi | OpenFOAM Meshing & Mesh Conversion | 0 | November 10, 2010 03:23 |
physical boundary error!! | kris | Siemens | 2 | August 3, 2005 00:32 |