[eRzBeNgEl]

Hi

I am running a unsteady implicit k-e Modell Model. Always if I am going to start my simulation this failure comes up:

"Attempt to access unallocated DensityLevel1 storage in cells Inlet"

I don´t get it, my simulation worked before (with a smaller mesh), I just increased the mesh resolution and that´s it.

Anynone can help?


Thanks

[siara817]

Hi,
I got the same error and I solved it as follow:
In the " Representations" I removed all meshes except "Volume mesh".
from " Volume mesh" I extracted the surface mesh.
The problem was solved.
I think the reason is that, volume mesh and surface mesh became the same.
Good luck

[rwryne]

Originally Posted by eRzBeNgEl

Hi

I am running a unsteady implicit k-e Modell Model. Always if I am going to start my simulation this failure comes up:

"Attempt to access unallocated DensityLevel1 storage in cells Inlet"

I don´t get it, my simulation worked before (with a smaller mesh), I just increased the mesh resolution and that´s it.

Anynone can help?


Thanks

I am not 100% certain since I have not had this problem, but it sounds like your solution did not get interpolated correctly to the new mesh. You might have to clear the solution completely on the new mesh and start from your initial conditions again.