 |
 |
 |
|
|
|
[Sponsors] | ||||
May 6, 2013, 00:08
|
couple errors
|
#1 |
|
New Member
jiehesfafn
Join Date: Apr 2013
Posts: 1
Rep Power: 0  |
I have a problem as follows
the model has two part, the mesh node is not connect, so I need to make couples between them and then transform couples, the nodes could be connect. But when I do this step, the software has the warnings: FACE DEFINED BY VERTICES IS DEFINED IN MORE THAN 2 CELLS. In my experience, the errors are usually in curved surface, the flat surface has no problem in this step. How to solve this problem, waiting for answer, thanks a lot. |
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Building OpenFOAM1.7.0 from source | ata | OpenFOAM Installation | 42 | May 14, 2012 20:48 |
| Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 04:03 |
| IcoFoam parallel woes | msrinath80 | OpenFOAM Running, Solving & CFD | 9 | July 22, 2007 02:58 |
| Could anybody help me see this error and give help | liugx212 | OpenFOAM Running, Solving & CFD | 3 | January 4, 2006 18:07 |
| Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ... | 2 | July 15, 2005 04:15 |
Linear Mode
