|
[Sponsors] |
September 30, 2009, 17:59 |
Manipulating Tolerances in "eoslide" command
|
#1 |
New Member
Sameera Wijeyakulasuriya
Join Date: Aug 2009
Posts: 12
Rep Power: 16 |
Does anyone know how to manipulate the tolences given in "eoslide" command, which is used in ASI (Arbitrary Sliding Interface). I need to know how to change the default tolerances when the cell sizes across the sliding interface is getting smaller and not equal in size? (Say the master cell is 5 times larger that the slave cell)
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Working directory via command line | Luiz | CFX | 4 | March 6, 2011 20:02 |
Installation OF1.5-dev | ttdtud | OpenFOAM Installation | 46 | May 5, 2009 02:32 |
OpenFOAM15 installables are incomplete problem with paraFoam | tryingof | OpenFOAM Bugs | 17 | December 7, 2008 04:41 |
Problem of compilation OF 14Allwmake command not found | erik_d | OpenFOAM Bugs | 13 | September 13, 2008 21:45 |
Regarding FoamX running Kindly help out | hariya03 | OpenFOAM Pre-Processing | 0 | April 18, 2008 04:26 |