Problem with Injection

hang1984 · June 8, 2010, 08:16

Hello everyone,
i'm working on a Spraysimulation in motor. And i've defined some injectors which should inject after 1 deg. But i received a error in the Droplet-post that there is no droplet. And i ve checked the *.spd01 file that it accually didn't inject.
The Droplet type and Mass flow Rate have no Prolem, i think.
The modell was imported from es-ice.
i've no idea where can be the prolem. So,
Could someone tell me some possible reasons?
Thx in advance
Best regards

hang1984 · June 10, 2010, 05:42

Hi
i have tried yesterday to inject not diesel which i ve defeined as droplet but water. it injected. but after i changed it to diesel back,it could not inject again.
i guess it can be a problem with the droplet properties. but i've checked the panel. there is nothing different with my another model which untill now works good.
could anyone else give me some tipps?
thx in advance!

hang1984 · June 14, 2010, 05:11

hi everyone,
Problem solved. i just deleted the 1. droplet type and defeined new droplet type, on second place, nothing different with the first. at the end it injected.
although i didn't understand at all, why it was like this. but at least i can continue my work.
it may give you some useful info, if you face the same Problem.

best regards
hang

June 8, 2010, 08:16	Problem with Injection	#1
hang1984 New Member hang zhu Join Date: May 2010 Posts: 10 Rep Power: 15	Hello everyone, i'm working on a Spraysimulation in motor. And i've defined some injectors which should inject after 1 deg. But i received a error in the Droplet-post that there is no droplet. And i ve checked the *.spd01 file that it accually didn't inject. The Droplet type and Mass flow Rate have no Prolem, i think. The modell was imported from es-ice. i've no idea where can be the prolem. So, Could someone tell me some possible reasons? Thx in advance Best regards

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Adiabatic and Rotating wall (Convection problem)	ParodDav	CFX	5	April 29, 2007 19:13
DPM injection problem	akr	FLUENT	5	November 6, 2006 10:34
problem in solving "wave generation" problem	san	FLUENT	2	April 3, 2006 23:37
problem with using colocated code	Jack	Main CFD Forum	0	December 15, 2002 00:15
Is this problem well posed?	Thomas P. Abraham	Main CFD Forum	5	September 8, 1999 14:52

June 10, 2010, 05:42		#2
hang1984 New Member hang zhu Join Date: May 2010 Posts: 10 Rep Power: 15	Hi i have tried yesterday to inject not diesel which i ve defeined as droplet but water. it injected. but after i changed it to diesel back,it could not inject again. i guess it can be a problem with the droplet properties. but i've checked the panel. there is nothing different with my another model which untill now works good. could anyone else give me some tipps? thx in advance!

June 14, 2010, 05:11		#3
hang1984 New Member hang zhu Join Date: May 2010 Posts: 10 Rep Power: 15	hi everyone, Problem solved. i just deleted the 1. droplet type and defeined new droplet type, on second place, nothing different with the first. at the end it injected. although i didn't understand at all, why it was like this. but at least i can continue my work. it may give you some useful info, if you face the same Problem. best regards hang