 |
 |
 |
|
|
|
[Sponsors] | ||||
September 6, 2011, 03:58
|
About Two Stroke engine simulation
|
#1 |
|
New Member
Kevin
Join Date: Aug 2011
Posts: 1
Rep Power: 0  |
Hi everyone, I'm doing simulation on a two stroke engine using star-cd 4.08. The ASI method is used to connect the intake ports and cylinder. But I can make the two domain connect and the the attach walls are always unmatched. Could anybody give some advices about this? How can I do it? Thank you very much.
kevin |
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Turbulent simulation of Ramjet engine intake | mecbe2002 | OpenFOAM | 0 | June 25, 2010 07:19 |
| Compressible Flow Simulation - business jet | Tyler | FLUENT | 0 | March 13, 2009 15:47 |
| Simulation of a four stroke engine cycle | Alfred Herman.S. | CD-adapco | 1 | May 27, 2002 07:05 |
| compression stroke in piston engine | Hassaneen | CD-adapco | 12 | December 29, 2000 12:30 |
| Question concerning about the flow simulation of a fan in an engine room. | ghlee | Main CFD Forum | 3 | October 21, 1998 07:05 |
Linear Mode
