Error 250: Cannot Find Location for Injector

Phanipavan · December 25, 2011, 23:43

Hi all,
I am facing this error while running simulation of diesel engine

Error 250 : Cannot Find Location For Injector

I have defined Coordinate system for Injector in prostar ,the location of injector is at center of cell ,but after INITFI Method invoked,this error is recurring.

Please help.

aziz56 · December 27, 2011, 02:29

u have defined ur coordinating system as in the mesh with respect to the local 1 or without that .
u can try to define them normally without fortran and u will see if they are false o true .. (as another way )

salut
aziz

Phanipavan · December 27, 2011, 11:21

Thanks aziz,i got it

December 27, 2011, 02:29	Injector problem ??	#2
aziz56 New Member Join Date: Mar 2011 Posts: 11 Rep Power: 3	u have defined ur coordinating system as in the mesh with respect to the local 1 or without that . u can try to define them normally without fortran and u will see if they are false o true .. (as another way ) salut aziz

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
OpenFoam171: error /usr/bin/ld: cannot find -llduSolvers	Schipper	OpenFOAM Running, Solving & CFD	2	June 1, 2011 12:36
Ways to find Mass transfer coefficient using CFD?	tuks_123	CFX	10	April 15, 2011 11:20
How to find center of pressure	cfdnewbie1	STAR-CCM+	3	February 16, 2011 09:52
Find X,Y,Z Location of maxVal (CFX-Post)	andygir	CFX	7	December 23, 2010 10:09
Find location @ Line where a variable has a certain value	camoesas	CFX	6	May 6, 2010 01:52

December 27, 2011, 11:21		#3
Phanipavan New Member Pavan Kumar Join Date: Jun 2011 Posts: 5 Rep Power: 2	Thanks aziz,i got it