|July 28, 2014, 11:20||
beam188 DOF release
Join Date: Jun 2014
Posts: 5Rep Power: 3
I am having problems to simulate a pot bearing on a bridges' column-Deck connection. I tried the ENDRELEASE command but I can't figure out how to apply this command.
By following the path:
Main Menu>Preprocessor>Loads>Load Step Opts>Other>End Releases>Beams>On Selected set
We are supose to chose a node (or a set) to set free the DOF's. But this command creates new nodes and makes the strucutre to split on those nodes. And I can't understand this behavior.
Can someone please help?
Thanks in advance,
|Thread||Thread Starter||Forum||Replies||Last Post|
|Release of foam-extend-3.0||hjasak||OpenFOAM Announcements from Other Sources||2||September 21, 2014 07:08|
|Openfoam Ubuntu 12.04 Unmet dependencies||slls33||OpenFOAM Installation||10||April 9, 2013 04:16|
|Force can not converge||colopolo||CFX||13||October 4, 2011 22:03|
|Extend Project Release 1.6-ext||hjasak||OpenFOAM Announcements from Other Sources||33||July 14, 2011 18:54|
|Diesel combustion simulation ( Heat release rate)||venkatesh||CD-adapco||2||April 29, 2009 07:38|