|
[Sponsors] |
ANSYS - Model of rotating bead embedded inside a support |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 2, 2015, 05:37 |
ANSYS - Model of rotating bead embedded inside a support
|
#1 |
New Member
Cedric
Join Date: Feb 2015
Posts: 1
Rep Power: 0 |
Good morning everybody,
I am totally new here but I believe you can help me. I have a model of a bead rotating on a support in 2D. It is a bead half embedded in a support and I apply a torque upon it (model of magnetic twisting cytometry). Then I need to measure the rotation made by the bead. I tried to use Remote points. I select the edge of the bead in the Remote but it always gives me 0 in each rotation angle. The commands I used were : My-node =_npilot in the commands of remote point. And my_rotx = ROTX (My-node) Same for each axis. I would be totally grateful if you could help me finding why. I can provide a sketch if needed... Thank uou very much, Cedric |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rotating Wind turbine rotor model step up | shiyun | CFX | 3 | November 6, 2017 10:34 |
Superlinear speedup in OpenFOAM 13 | msrinath80 | OpenFOAM Running, Solving & CFD | 18 | March 3, 2015 05:36 |
[Other] How to create an MRF zone ? | aminem | OpenFOAM Meshing & Mesh Conversion | 2 | December 8, 2014 10:45 |
Ansys CFX support for ubuntu | LUIS1717 | CFX | 0 | May 17, 2014 15:07 |
ansys customer support | marvin | CFX | 2 | May 20, 2008 20:22 |