 |
 |
 |
|
|
|
[Sponsors] | ||||
January 24, 2014, 11:21
|
Open Rotor TestCase problem
|
#1 |
|
New Member
Join Date: Jan 2014
Posts: 1
Rep Power: 0  |
I am trying to run the open_rotor test case. Even though the input file has RESTART_SOL=NO, the code still crashes with the following error message. I am sure this is something very simple, and appreciate the help in advance.
------------------------- Solver Preprocessing -------------------------- Area projection in the z-plane = 0.0748494. Initialize jacobian structure (Euler). MG level: 0. There is no flow restart file!! solution_flow.dat. |
|
|
|
|
|
January 28, 2014, 15:36
|
|
#2 |
|
Member
Trent Lukaczyk
Join Date: Feb 2011
Location: Stanford, CA
Posts: 75
Rep Power: 15 |
you might have it set to MATH_PROBLEM=ADJOINT, in which case it would look for this file. Make sure MATH_PROBLEM=DIRECT
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [swak4Foam] Error bulding swak4Foam | sfigato | OpenFOAM Community Contributions | 18 | August 22, 2013 12:41 |
| Problem installing on Ubuntu 9.10 -> 'Cannot open : No such file or directory' | mfiandor | OpenFOAM Installation | 2 | January 25, 2010 09:50 |
| open channel problem (free surface) | Andy Chen | FLUENT | 4 | July 10, 2009 01:20 |
| How did I set a discharge or depth curve at inflow boundary? (open channel problem) | Andy Chen | FLUENT | 0 | June 29, 2009 10:11 |
| Problem in Installation of Open Foam | Shishir | OpenFOAM Installation | 2 | May 28, 2009 15:05 |
Linear Mode
