 |
 |
 |
|
|
|
[Sponsors] | ||||
Generating a binary data file without using tecio |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 18, 2012, 19:16
|
Generating a binary data file without using tecio
|
#1 |
|
New Member
abc
Join Date: Jun 2012
Posts: 1
Rep Power: 0  |
Hi all,
I am new to Tecplot. I am asked to write a C program to generate a binary data file without using tecio.h. I read the "binary data file format" on the manual, but I am still not sure what the program should look like. Can someone give me an example of a C program which can generate a binary file without using tecio? Thanks! Tom10 |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [swak4Foam] groovyBC in openFOAM-2.0 for parabolic velocity bc | ofslcm | OpenFOAM Community Contributions | 25 | March 6, 2017 10:03 |
| [blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |
| Doxygen documentation | Tanay | OpenFOAM Installation | 9 | September 23, 2011 11:40 |
| [blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
| Error to re-open fluent case file | J.Gimbun | FLUENT | 0 | April 27, 2006 08:42 |
Linear Mode
