|January 12, 2013, 15:26||
openfoam data boundaries merged when use foamDataToTecplot tool,
Join Date: May 2011
Posts: 9Rep Power: 7
when I use foamDataToTecplot to export openfoam data to tecplot, then in tecplot the data only contains one region, I mean before I set the boundaries are velocity_in， Pressure_out, symmetry, wall. but after use that convert tool, only one region (all boundaries are merged into the whole domain) is available in tecplot.
Does anyone know how to separate the boundaries when export the foam data?
|Thread||Thread Starter||Forum||Replies||Last Post|
|how to create cyclic from 2 boundaries in Openfoam 1.7.1||vsflap||OpenFOAM||4||April 26, 2013 03:30|
|New OpenFOAM Forum Structure||jola||OpenFOAM||2||October 19, 2011 06:55|
|64bitrhel5 OF installation instructions||mirko||OpenFOAM Installation||2||August 12, 2008 18:07|
|OpenFOAM Debian packaging current status problems and TODOs||oseen||OpenFOAM Installation||9||August 26, 2007 13:50|
|OpenFOAM Training and Workshop Zagreb 2628Jan2006||hjasak||OpenFOAM||1||February 2, 2006 22:07|