Home > Forums > Tecplot

Boundary layer thickness

Mark Forums Read

Reply

April 8, 2013, 09:48	Boundary layer thickness	#1
j_h_86 Member Johannes Ringborn Join Date: Nov 2012 Posts: 36 Rep Power: 2	Hello, I want to calculate the boundary layer thickness of a curved geometry. The calculation was done on an unstructured mesh. The reference velocity u_infinity is known. Is this doable with Tecplot (prefered) or CFX post? Best regards

Reply

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
No layers in a small gap	bobburnquist	OpenFOAM Native Meshers: snappyHexMesh and Others	2	November 25, 2012 08:54
The boundary layer thickness on an airfoil	Nick R	Main CFD Forum	4	September 14, 2012 03:50
Questions about Boundary Layer Thickness and Turbulence Models	famerfamer	STAR-CCM+	3	July 12, 2012 09:47
Boundary Layer roughness/ low reynolds wall treatment	Luigi_	STAR-CCM+	1	March 14, 2012 09:40
Boundary layer thickness	ghazanfarzahedi	Main CFD Forum	2	July 28, 2009 23:43

All times are GMT -4. The time now is 01:36.