CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   Tecplot (http://www.cfd-online.com/Forums/tecplot/)
-   -   How to deal with grid at the cell center ? (http://www.cfd-online.com/Forums/tecplot/119182-how-deal-grid-cell-center.html)

Voyage_gui June 11, 2013 10:44

How to deal with grid at the cell center ?
 
Hi everyone,

I have data located at cell centered. The hic is that for the mesh location i have only points at cell center location.
I ve tried to use "cellcentered" with this header :

VARIABLES = "X", "Y", "Z", "DATA",
zone I=10, J=15, K= 2
, DATAPACKING=BLOCK,VARLOCATION=([1,2,3,4]=CELLCENTERED)

Tecplot don't understand and give me 2 errors :
1) Aspect ratio exceeds ratio limit. The ratio has been adjusted
2) Axis Mode has been reset to be Independent

In 3D the cells are upside down.

(The loader in Paraview says that :
Unable to find any meshes)

If anyone has a solution to load this mesh.

Best

Guillaume


All times are GMT -4. The time now is 12:15.