|June 11, 2013, 10:44||
How to deal with grid at the cell center ?
Join Date: Sep 2010
Posts: 30Rep Power: 7
I have data located at cell centered. The hic is that for the mesh location i have only points at cell center location.
I ve tried to use "cellcentered" with this header :
VARIABLES = "X", "Y", "Z", "DATA",
zone I=10, J=15, K= 2
Tecplot don't understand and give me 2 errors :
1) Aspect ratio exceeds ratio limit. The ratio has been adjusted
2) Axis Mode has been reset to be Independent
In 3D the cells are upside down.
(The loader in Paraview says that :
Unable to find any meshes)
If anyone has a solution to load this mesh.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Question regarding non-uniform FVM staggered grid||quarkz||Main CFD Forum||2||June 18, 2011 17:18|
|Cells with t below lower limit||Purushothama||CD-adapco||2||May 31, 2010 21:58|
|Can a grid cell be too small?||Danny||FLUENT||0||August 16, 2005 09:19|
|On grid independent solution for pulsatile flow||David||FLUENT||4||June 8, 2005 16:20|
|Getting cell center coordinates in Star-CD 3.22||Vitmalin||CD-adapco||1||November 25, 2004 23:24|