CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Visualization & Post-Processing Software > Tecplot

on Tecplot

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   August 21, 2006, 11:36
Default on Tecplot
  #1
Vic
Guest
 
Posts: n/a
I have some results for flow around an airfoil in a wall-bounded domain (something like an airfoil installed in a test section of a wind tunnel). In TECPLOT, it is easy to create a slice in any direction and see the 2D streamlines. But, I would like to remove the solid walls so that the only thing that I see is the airfoil and the 3D streamlines around it.

Or in another but similar case, there is a 3D rectangular domain (like a box) and a duct is attached to the lower surface and let some amount of air goes out. Again, I want to remove all solid boundaries except for the duct and the flat plat (side) that this duct is attached to, so that I can see how the streamlines approach and enter the duct.

I appreciate any advice/idea on how I can manage this.

Vic

  Reply With Quote

Old   August 28, 2006, 08:49
Default Re: on Tecplot
  #2
Gerrit
Guest
 
Posts: n/a
I'm afraid you can't. If you want to take away the walls they should have been saved as separate zones from the beginning, you then just turn off that zone. Or maybe you just have to turn off the boundary on the left hand side.

If the're not saved as separate zones... ...you can't

I hope I understand your question.
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Importing contour maps into Tecplot jcostex Tecplot 1 May 20, 2009 13:48
Problem Exporting to Tecplot Craig FLUENT 2 July 16, 2008 00:21
How to read tecplot file witout tecplot ? Pol Tecplot 11 March 2, 2007 07:26
Using Tecplot for contours display david FLUENT 2 August 23, 2005 23:37
Tecplot can't read data file from Fluent. stephen FLUENT 8 November 21, 2001 21:27


All times are GMT -4. The time now is 07:37.