|May 30, 2015, 18:46||
Writing title of axis in Tecplot
Join Date: Nov 2013
Posts: 372Rep Power: 6
My version of software is Tecplot 360.
I want to write unit of a parameter in the front of that. This parameter is title of a axis.
In fact, I wrote F<sub>len by writing in Axis Details>Use text. Finally, It is almost created a parameter like F_gen.
Then,when I write unit of expressed parameter in the front of that, Its unit places in index, Why? I dont know that how to write this unit that It places exactly in front of expressed parameter.
I am grateful that guide me about this problem.
|Thread||Thread Starter||Forum||Replies||Last Post|
|How to Mix AIR and WATER||Elvis1991||FLUENT||12||December 1, 2016 13:28|
|refineWallLayer Error||Yuby||OpenFOAM Meshing & Mesh Conversion||0||April 27, 2015 18:25|
|Contribution a new utility: refine wall layer mesh based on yPlus field||lakeat||OpenFOAM Mesh Utilities||57||February 1, 2015 09:25|
|crash sHM||H25E||OpenFOAM Native Meshers: snappyHexMesh and Others||11||November 10, 2014 12:27|
|How to make the axis value change with an animation when using tecplot?||bhbuaa||Tecplot||0||August 12, 2014 12:10|