|
[Sponsors] |
May 30, 2015, 18:46 |
Writing title of axis in Tecplot
|
#1 |
Senior Member
Aja
Join Date: Nov 2013
Posts: 496
Rep Power: 14 |
Hi,
My version of software is Tecplot 360. I want to write unit of a parameter in the front of that. This parameter is title of a axis. In fact, I wrote F<sub>len by writing in Axis Details>Use text. Finally, It is almost created a parameter like F_gen. Then,when I write unit of expressed parameter in the front of that, Its unit places in index, Why? I dont know that how to write this unit that It places exactly in front of expressed parameter. I am grateful that guide me about this problem. Best, Amir |
|
May 31, 2015, 04:24 |
|
#2 |
Senior Member
Aja
Join Date: Nov 2013
Posts: 496
Rep Power: 14 |
No-one help?
|
|
December 7, 2015, 09:53 |
|
#3 |
Member
Join Date: Feb 2014
Posts: 57
Rep Power: 12 |
Hi,
You can try F<s>len</s> |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] Contribution a new utility: refine wall layer mesh based on yPlus field | lakeat | OpenFOAM Community Contributions | 58 | December 23, 2021 02:36 |
[Other] refineWallLayer Error | Yuby | OpenFOAM Meshing & Mesh Conversion | 2 | November 11, 2021 11:04 |
How to Mix AIR and WATER | Elvis1991 | FLUENT | 12 | December 1, 2016 12:28 |
[snappyHexMesh] crash sHM | H25E | OpenFOAM Meshing & Mesh Conversion | 11 | November 10, 2014 11:27 |
How to make the axis value change with an animation when using tecplot? | bhbuaa | Tecplot | 0 | August 12, 2014 12:10 |