CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   Tecplot (http://www.cfd-online.com/Forums/tecplot/)
-   -   Vector direction in tecplot! (http://www.cfd-online.com/Forums/tecplot/2723-vector-direction-tecplot.html)

Bill October 24, 2000 10:55

Vector direction in tecplot!
 
Hi, there:

I find a strange problem in Tecplot. There are three ways to define vector length in Tecplot. However, I find the vector directions are different when I use Relative(Grid units/magnitude) or Relative(cm units/magnitude). Do you have the same experience? Can anybody suggest the reasons? Thank you in advance.

Bill

oliver October 27, 2000 17:31

Re: Vector direction in tecplot!
 
Hi

Is the grid scale, the same in the x, y & z direction?.

Regards

Oliver.


All times are GMT -4. The time now is 14:24.