 |
 |
 |
|
|
|
[Sponsors] | ||||
October 24, 2000, 10:55
|
Vector direction in tecplot!
|
#1 |
|
Guest
Posts: n/a
|
Hi, there:
I find a strange problem in Tecplot. There are three ways to define vector length in Tecplot. However, I find the vector directions are different when I use Relative(Grid units/magnitude) or Relative(cm units/magnitude). Do you have the same experience? Can anybody suggest the reasons? Thank you in advance. Bill |
|
|
||
|
October 27, 2000, 17:31
|
Re: Vector direction in tecplot!
|
#2 |
|
Guest
Posts: n/a
|
Hi
Is the grid scale, the same in the x, y & z direction?. Regards Oliver. |
|
|
|
||
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Importing contour maps into Tecplot | jcostex | Tecplot | 1 | May 20, 2009 12:48 |
| Problem Exporting to Tecplot | Craig | FLUENT | 2 | July 15, 2008 23:21 |
| How to read tecplot file witout tecplot ? | Pol | Tecplot | 11 | March 2, 2007 06:26 |
| Using Tecplot for contours display | david | FLUENT | 2 | August 23, 2005 22:37 |
| Tecplot can't read data file from Fluent. | stephen | FLUENT | 8 | November 21, 2001 20:27 |
Linear Mode
