# Diffusion term

### From CFD-Wiki

(difference vector incorrectly defined (compare with picture!)) |
|||

(23 intermediate revisions not shown) | |||

Line 1: | Line 1: | ||

- | ==Discretisation of | + | ==Discretisation of the diffusion term == |

=== Description=== | === Description=== | ||

<br> | <br> | ||

- | + | For a general control volume (orthogonal, non-orthogonal), the discretization of the diffusion term can be written in the following form<br> | |

- | <br> | + | |

- | + | :<math> \int_{S}\Gamma\nabla\phi\cdot{\rm{d\vec S}} = \sum_{faces}\Gamma _f \nabla \phi _f \cdot{\rm{\vec S_f}} </math> <br> | |

- | <br> | + | where |

- | [[Image: | + | *S denotes the surface area of the control volume |

- | ''' | + | *<math>S_f</math> denotes the area of a face for the control volume |

- | + | As usual, the subscript f refers to a given face. The figure below describes the terminology used in the framework of a general '''non-orthogonal''' control volume<br> | |

- | <math> \vec r_{ | + | [[Image:non_orthogonal_CV_terminology.jpg]] <br> |

- | <math> | + | '''A general non-orthogonal control volume''' <br> |

+ | |||

+ | |||

+ | If <math> \vec r_{P} </math> and <math> \vec r_{N} </math> are position vector of centroids of cells P and N respectively. Then, we define <br> | ||

+ | :<math> \overrightarrow{d_{PN}}= \vec r_{N} - \vec r_{P} </math> | ||

+ | |||

<br> | <br> | ||

- | We wish to approaximate <math> D_f = \Gamma _f \nabla \phi _f \ | + | We wish to approaximate the diffusive flux <math> D_f = \Gamma _f \nabla \phi _f \cdot{\rm{\vec S_f}} </math> at the face. |

=== Approach 1 === | === Approach 1 === | ||

- | + | A first approach is to use a simple expression for estimating the gradient of a scalar normal to the face. <br> | |

:<math> | :<math> | ||

- | D_f = \Gamma _f \nabla \phi _f \ | + | D_f = \Gamma _f \nabla \phi _f \cdot \vec S_f = \Gamma _f \left[ {\left( {\phi _N - \phi _P } \right)\left| {{{\vec S_f} \over {\overrightarrow{d_{PN}}}}} \right|} \right] |

</math> <br> | </math> <br> | ||

- | where <math> \Gamma _f </math> is suitable face | + | where <math> \Gamma _f </math> is a suitable face average. <br> |

- | This approach is not very good when the non-orthogonality of the faces increases. | + | This approach is not very good when the non-orthogonality of the faces increases. If this is the case, it is advisable to use one of the following approaches. <br> |

=== Approach 2 === | === Approach 2 === | ||

- | We define vector | + | We define the vector |

- | <math> | + | :<math> |

- | \vec \alpha {\rm{ = }}\frac{{{\rm{\vec | + | \vec \alpha {\rm{ = }}\frac{{{\rm{\vec {S_f}}}}}{{{\rm{\vec S_f}} \cdot {\overrightarrow{d_{PN}}}}} |

</math> | </math> | ||

giving us the expression: <br> | giving us the expression: <br> | ||

:<math> | :<math> | ||

- | D_f = \Gamma _f \nabla \phi _f \ | + | D_f = \Gamma _f \nabla \phi _f \cdot{\rm{\vec S_f = }}\Gamma _{\rm{f}} \left[ {\left( {\phi _N - \phi _P } \right)\vec \alpha \cdot {\rm{\vec S_f + }}\bar \nabla \phi_f \cdot {\rm{\vec S_f - }}\left( {\bar \nabla \phi_f \cdot {\overrightarrow{d_{PN}}}} \right)\vec \alpha \cdot {\rm{\vec S_f}}} \right] |

</math> <br> | </math> <br> | ||

where <math> \bar \nabla \phi _f </math> and <math> \Gamma _f </math> are suitable face averages. <br> | where <math> \bar \nabla \phi _f </math> and <math> \Gamma _f </math> are suitable face averages. <br> | ||

+ | |||

+ | === Orthogonal correction approaches === | ||

+ | In non-orthogonal grids, the gradient direction that will yield an expression involving the values at the neighboring control volumes will have to be along the line joining the centroids of the two control volumes. If this direction has a unit vector denoted by <math>\vec e</math> then, by definition <br> | ||

+ | :<math> | ||

+ | \vec e {\rm{ = }} \frac{{{\rm{\overrightarrow{d_{PN}}}}}} {\left| {\overrightarrow{d_{PN}}} \right|} | ||

+ | </math><br> | ||

+ | then the gradient in the direction of <math>\vec e</math> can be written as <br> | ||

+ | :<math> \nabla \phi _f \cdot \vec e = \frac {\partial \phi_f} {\partial e} = \frac { \phi_N - \phi_P} {\left| {\overrightarrow{d_{PN}}} \right|} </math> <br> | ||

+ | |||

+ | If the surface vector <math>\vec {S_f}</math> is written as the summation of two vectors <math>\vec {E}</math> and <math>\vec {T}</math> <br> | ||

+ | :<math>\vec {S_f} = \vec {E} + \vec {T}</math> <br> | ||

+ | where <math>\vec {E}</math> is in the direction joining the centroids of the two control volumes, we will then be able to express the diffusive flux in terms of the neighboring control volumes plus an additional correction. This is done as follows <br> | ||

+ | |||

+ | :<math> \nabla \phi_f \cdot \vec {S_f} = \nabla \phi_f \cdot \vec {E} + \nabla \phi_f \cdot \vec {T} </math> <br> | ||

+ | |||

+ | :<math> \nabla \phi_f \cdot \vec {S_f} = E \nabla \phi_f \cdot \vec {e} + \nabla \phi_f \cdot \vec {T} </math> .... (where E is the magnitude of <math> \vec E </math><br> | ||

+ | At the outset, one obtains <br> | ||

+ | :<math> \nabla \phi_f \cdot \vec {S_f} = E \frac { \phi_N - \phi_P} {\left| {\overrightarrow{d_{PN}}} \right|} + \nabla \phi_f \cdot \vec {T} </math> <br> | ||

+ | <br> | ||

+ | The first term in the above equation can be thought of as the orthogonal contribution to the diffusive flux, while the second term represents the non-orthogonal effects. At this point, the vector <math>\vec {T}</math> has not been defined yet. There are three main methods to define this vector. | ||

+ | |||

+ | ==== Minimum correction ==== | ||

+ | In the minimum correction approach, the vectors are defined as <br> | ||

+ | :<math> \vec E = (\vec e \cdot \vec S_f)\cdot \vec e = S_f \cos\theta \vec e </math> <br> | ||

+ | :<math> \vec T = \vec S - \vec E= S_f (\vec n - \cos\theta \vec e) </math> <br> | ||

+ | [[image:Non_orthogonal_CV_minimum_correction.jpg]] <br> | ||

+ | '''Minimum Correction Approach''' | ||

+ | |||

+ | ==== Orthogonal correction ==== | ||

+ | In the orthogonal correction approach, the vectors are defined as <br> | ||

+ | :<math> \vec E = S_f \vec e </math> <br> | ||

+ | :<math> \vec T = \vec S - \vec E = S_f (\vec n - \vec e) </math> <br> | ||

+ | [[image:Non_orthogonal_CV_orthogonal_correction.jpg]] <br> | ||

+ | '''Orthogonal Correction Approach''' | ||

+ | |||

+ | ==== Over relaxed correction ==== | ||

+ | Finally, in the over relaxed approach, we define <br> | ||

+ | :<math> \vec E = \frac {\vec S_f \cdot \vec S_f}{\vec S_f \cdot \vec e} \vec e = \frac {S_f}{\cos \theta} \vec e </math> <br> | ||

+ | :<math> \vec T = \vec S - \vec E = S_f (\vec n - \frac{1}{\cos \theta} \vec e) </math> <br> | ||

+ | [[image:Non_orthogonal_CV_Over_relaxed_correction.jpg]] <br> | ||

+ | '''Over Relaxed Correction Approach''' | ||

+ | |||

+ | == References == | ||

+ | |||

+ | #{{reference-book|author=Ferziger, J.H. and Peric, M.|year=2001|title=Computational Methods for Fluid Dynamics|rest=ISBN 3540420746, 3rd Rev. Ed., Springer-Verlag, Berlin.}} | ||

+ | #{{reference-paper|author=[http://www.h.jasak.dial.pipex.com/ Hrvoje, Jasak]|year=1996|title=Error Analysis and Estimation for the Finite Volume Method with Applications to Fluid Flows|rest=PhD Thesis, Imperial College, University of London ([http://www.h.jasak.dsl.pipex.com/HrvojeJasakPhD.pdf download])}} | ||

+ | #{{reference-paper|author=[http://webfea-lb.fea.aub.edu.lb/fea/me/CFD/ Darwish, Marwan]|year=2003|title=CFD Course Notes|rest=Notes, American University of Beirut}} | ||

+ | #{{reference-paper|author=[http://jedi.knows.it/ Saad, Tony]|year=2005|title=Implementation of a Finite Volume Unstructured CFD Solver Using Cluster Based Parallel Computing|rest=Thesis, American University of Beirut}} | ||

+ | |||

+ | ---- | ||

+ | <i> Return to [[Numerical methods | Numerical Methods]] </i> |

## Latest revision as of 07:32, 22 January 2010

## Contents |

## Discretisation of the diffusion term

### Description

For a general control volume (orthogonal, non-orthogonal), the discretization of the diffusion term can be written in the following form

where

- S denotes the surface area of the control volume
- denotes the area of a face for the control volume

As usual, the subscript f refers to a given face. The figure below describes the terminology used in the framework of a general **non-orthogonal** control volume

**A general non-orthogonal control volume**

If and are position vector of centroids of cells P and N respectively. Then, we define

We wish to approaximate the diffusive flux at the face.

### Approach 1

A first approach is to use a simple expression for estimating the gradient of a scalar normal to the face.

where is a suitable face average.

This approach is not very good when the non-orthogonality of the faces increases. If this is the case, it is advisable to use one of the following approaches.

### Approach 2

We define the vector

giving us the expression:

where and are suitable face averages.

### Orthogonal correction approaches

In non-orthogonal grids, the gradient direction that will yield an expression involving the values at the neighboring control volumes will have to be along the line joining the centroids of the two control volumes. If this direction has a unit vector denoted by then, by definition

then the gradient in the direction of can be written as

If the surface vector is written as the summation of two vectors and

where is in the direction joining the centroids of the two control volumes, we will then be able to express the diffusive flux in terms of the neighboring control volumes plus an additional correction. This is done as follows

- .... (where E is the magnitude of

At the outset, one obtains

The first term in the above equation can be thought of as the orthogonal contribution to the diffusive flux, while the second term represents the non-orthogonal effects. At this point, the vector has not been defined yet. There are three main methods to define this vector.

#### Minimum correction

In the minimum correction approach, the vectors are defined as

#### Orthogonal correction

In the orthogonal correction approach, the vectors are defined as

**Orthogonal Correction Approach**

#### Over relaxed correction

Finally, in the over relaxed approach, we define

**Over Relaxed Correction Approach**

## References

**Ferziger, J.H. and Peric, M. (2001)**,*Computational Methods for Fluid Dynamics*, ISBN 3540420746, 3rd Rev. Ed., Springer-Verlag, Berlin..**Hrvoje, Jasak (1996)**, "Error Analysis and Estimation for the Finite Volume Method with Applications to Fluid Flows", PhD Thesis, Imperial College, University of London (download).**Darwish, Marwan (2003)**, "CFD Course Notes", Notes, American University of Beirut.**Saad, Tony (2005)**, "Implementation of a Finite Volume Unstructured CFD Solver Using Cluster Based Parallel Computing", Thesis, American University of Beirut.

* Return to Numerical Methods *