CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Wiki > Hydraulic diameter

Hydraulic diameter

From CFD-Wiki

Revision as of 13:56, 24 March 2006 by Jola (Talk | contribs)
Jump to: navigation, search

The hydraulic diameter, d_h, is commonly used when dealing with non-circular pipes, holes or ducts.

The definition of the hydraulic diamater is:

d_h \equiv 4 \; \frac{\mbox{cross-sectional-area of duct}}{\mbox{wetted perimeter of duct}}

Contents

Use of hydraulic diameter

Hydraulic diameters for different duct-geometries

Using the definition above the hydraulic diamater can easily be computed for any type of duct-geometry. Below follows a few examples.

Circular pipe

For a circular pipe or hole the hydraulic diamater is:

d_h = 4 \; \frac{\frac{\pi d^2}{4}}{\pi d} = d

Where d is the real diameter of the pipe. Hence, for circular pipes the hydraulic diameter is the same as the real diameter of the pipe.

Rectangular tube

For a rectangular tube or hole with the width a and the height b the hydraulic diamter is:

d_h = 4 \; \frac{a b}{2 a + 2 b} = 2 \; \frac{a b}{a + b}

Coaxial circular tube

For a coaxial circular tube with an inner diameter d_i and an outer diameter d_o the hydraulic diameter is:

d_h = 4 \; \frac{\frac{\pi d_o^2}{4} - \frac{\pi d_i^2}{4}}{\pi d_o + \pi d_i} = d_o - d_i
My wiki