|
[Sponsors] |
February 20, 2016, 00:25 |
creating curves
|
#1 |
New Member
blake
Join Date: Feb 2016
Posts: 8
Rep Power: 10 |
hi friends,
can anyone please comment about how to create a curve which resembles a CON...my point is if there is a cuved CONS how can i create a curve which is of same size and shape and the new curve should lie on the CONS Thank You |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Problem creating two surfaces from two identical curves | KingKraut | ANSYS Meshing & Geometry | 1 | November 27, 2015 02:00 |
[ICEM] Curves deleted or concatenated when creating surface | Pilk | ANSYS Meshing & Geometry | 0 | October 20, 2014 09:39 |
Possible Bug in pimpleFoam (or createPatch) (or fluent3DMeshToFoam) | cfdonline2mohsen | OpenFOAM | 3 | October 21, 2013 09:28 |
[ICEM] Difficulty creating surfaces in ICEM | johnp | ANSYS Meshing & Geometry | 7 | May 14, 2013 04:22 |
Problem in running ICEM grid in Openfoam | Tarak | OpenFOAM | 6 | September 9, 2011 17:51 |