|
[Sponsors] |
![]() |
![]() |
#1 |
Member
António Soares
Join Date: Mar 2015
Location: Lisbon, Portugal
Posts: 48
Rep Power: 12 ![]() |
Greetings,
I apologize if this is a very basic thing to ask but I'm a relative novice to ANSA and so far I haven't found a simple way to turn an orange CON back to yellow without first releasing it and then reapplying the topology command to it. Is there an easier way to do this? |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Member
Maries
Join Date: Mar 2010
Location: Coimbatore, India
Posts: 77
Rep Power: 17 ![]() |
Yes you can do that. Mesh>macros>release will do that
|
|
![]() |
![]() |
![]() |
![]() |
#3 |
Member
António Soares
Join Date: Mar 2015
Location: Lisbon, Portugal
Posts: 48
Rep Power: 12 ![]() |
Thank you.
I thought it might be something in the Mesh deck but for some reason I didn't see the release command. Cheers, |
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM] Advice for fast paraview rendering | Tobi | ParaView | 1 | October 11, 2014 14:29 |
[ANSYS Meshing] Programs that I could use for fast meshing | zombiaska | ANSYS Meshing & Geometry | 1 | December 17, 2013 01:25 |
PC doesn't work fast | Luigi | Hardware | 7 | November 3, 2012 05:22 |
fast burning fuels | Mark | FLUENT | 1 | April 10, 2003 07:00 |