remeshing

Mrt23 · January 23, 2019, 14:57

hello All!
i have one easy question.
i have two three or four etc parts. Parts are connected by bolt (rbe-beam-rbe/ or rbe-rbe-rbe it doesn't matter). when i delete bolt and fill bolt holes i try to remesh area, but i can't do it. these areas aren't remeshed properly. i delete mesh in bigger area than filled holes and then i can do good mesh.
why so?

thank a lot!

Kapilraj_mech · April 1, 2019, 01:12

Hi Mrt23,

Try releasing the node(Deck-->Nodes-->Release) connected with the REB3/REB2 and pasted the released nodes. Before reconstruction check for free nodes, If there compress it.

January 23, 2019, 14:57	remeshing	#1
Mrt23 Member Join Date: Mar 2018 Posts: 56 Rep Power: 8	hello All! i have one easy question. i have two three or four etc parts. Parts are connected by bolt (rbe-beam-rbe/ or rbe-rbe-rbe it doesn't matter). when i delete bolt and fill bolt holes i try to remesh area, but i can't do it. these areas aren't remeshed properly. i delete mesh in bigger area than filled holes and then i can do good mesh. why so? thank a lot!

April 1, 2019, 01:12	Reconstruction	#2
Kapilraj_mech New Member Kapilraj Join Date: Mar 2019 Posts: 3 Rep Power: 7	Hi Mrt23, Try releasing the node(Deck-->Nodes-->Release) connected with the REB3/REB2 and pasted the released nodes. Before reconstruction check for free nodes, If there compress it.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Remeshing issue due to solid contact	Jrmy	FLUENT	4	October 18, 2018 16:34
CFX Remeshing failed ERROR	ashtonJ	CFX	6	September 16, 2016 15:41
Cfx solver fails after dynamic remeshing!	shivasluzz	CFX	0	December 17, 2015 07:17
ICEM CFD Replay Remeshing	EvaS	CFX	1	December 19, 2012 19:30
Bugg in Remeshing in 3D - Any Fluent Wizards ??	Amr	FLUENT	1	November 1, 2011 04:04