Home > Forums > Mesh Generation & Pre-Processing Software > ANSA

Periodicity

Mark Forums Read

Like Tree

1Likes

1 Post By phPatras

Reply

Search this Thread

February 16, 2019, 10:52	Periodicity	#1
phPatras New Member Mentzos Join Date: Dec 2010 Location: Athens Posts: 22 Rep Power: 15	I have problem with the periodicity. I want mesh only one channel from a centrifugal impeller with hexa and I can not...as i have periodicity conditions.. and I can not understand how...?

February 21, 2019, 03:59		#2
phPatras New Member Mentzos Join Date: Dec 2010 Location: Athens Posts: 22 Rep Power: 15	OK I Find it Mahmoud_aboukhedr likes this.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] Periodicity problems in icem	zeeshu	ANSYS Meshing & Geometry	0	April 17, 2016 20:59
[ICEM] ICEM periodicity specification	robboflea	ANSYS Meshing & Geometry	18	November 11, 2014 14:51
[ICEM] Two kinds of periodicity in one project	PS_KA	ANSYS Meshing & Geometry	3	January 22, 2014 04:09
[ICEM] Hybrid Meshing and Periodicity	RalfBecker	ANSYS Meshing & Geometry	0	October 31, 2013 06:31
translational periodicity	wasim	CFX	0	May 13, 2006 13:34

All times are GMT -4. The time now is 22:12.