|
[Sponsors] |
Defeature length or removing small length coons |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 24, 2019, 02:20 |
Defeature length or removing small length coons
|
#1 |
Member
Himanshu
Join Date: Jan 2017
Posts: 34
Rep Power: 9 |
Hello,
Previously, I was working on ANSYS Mesher and Fluent Meshing, in that there was an option to give defeaturing length where I can give some tolerance value and all the features within that tolerance value will not be consider for meshing thus removing the manual work to clean those small coons. I was looking for the same thing in ANSA. I am giving a constant length size for meshing which is the method we use (we don't use Auto CFD method). I wanted to is there an option to give a tolerance value in ANSA, where all the coons with in that value will not be considered for meshing. |
|
Tags |
ansa, ansa meshing, coons, defeaturing, defeaturing tolerance |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Characteristic length for the Grashof number in a tank with small horizontal heaters | sbesarati | Main CFD Forum | 3 | December 27, 2016 18:57 |
[snappyHexMesh] .STL: non-closed manifold surface | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 32 | November 25, 2016 03:15 |
Modelled Length Scale in SAS-SST Simulation | jego | Main CFD Forum | 0 | January 16, 2016 06:45 |
Very small recirculation length for flow over a circular cylinder | Tarak | OpenFOAM Running, Solving & CFD | 2 | August 31, 2011 11:27 |
Cases with small length scale work fine on a single processor but fail in parallel | adona058 | OpenFOAM Bugs | 5 | April 17, 2009 04:41 |